Catalog pricing shown. Please Sign In to see your pricing.

Arcoaire HP Single Phase Split System Multi Stg 2 Ton 24k BTU AHU 16 SEER2

Arcoaire HP Single Phase Split System Multi Stg 2 Ton 24k BTU AHU 16 SEER2
Kit Includes whip 6' 3/4" 6GA, No Vent Caps, 3" Plastic Pad, Surge Protector, 50' Line Set 1/2" Insul, PVC Adapters/Fittings, 6" Heat Pump Riser, PVC Trap Kit, Furnace Leveler, 2H/2C Thermostat, Disconnect

This retail set contains

Vendor Name:
Arcoaire
URI Part Number:
Arcoaire HP Single Phase Split System Multi Stg 2 Ton 24k BTU AHU 16 SEER2
Shipping Weight (Lbs.):
200
Energy Star:
Not Energy Star Compliant
Includes:
DLCURAH24AAK, FMA4X2400AL, HPKIT40
Nominal Capacity (BTUH):
24000
Cooling Efficiency (EER2):
9.5
Cooling Efficiency (SEER2):
16
Heating Efficiency HSPF2:
8.1
System Indoor Type:
AHU
System Outdoor Type:
Multi Stage
System Coil Configuration:
Front Return
System AHU Type:
Specialty AHU (Uncased, Apartment)
System Nominal Tons:
2
AHRI System Number:
211640994
Heat Pump, Single Phase, Split AHU Multi Stage, Front Return DLCURAH/FMA4

Heat Pump Inverter
  • Utilize expansion device on the indoor unit
  • Insulate suction line only
  • Anti corrosion coating
  • Built in algorithm learns and adapts
  • Monitors suction pressure/temperature (super heat) to regulatecompressor speed
  • Field adjustable timer (ramps up to 100% if thermostat not satisfied)
  • Automatically ramps up/down 30-120% rated capacity
  • Field set sw 1-3 to A/C only
  • Low ambient cooling to -22°F
  • Pre charged for 25' tubing
Front Return Fan Coils
  • Factory installed TXV (4X) - Piston (4P)
  • EC motor (4X) - PSC Motor (4P)
  • Motor suspended on rubber grommets for quieter operation
  • Standard return air grille panel and is convertible to bottom return
  • Replaceable air filter factory supplied with all models
  • Fully insulated for conditioned space (not to be installed in unconditioned spaces)
  • Upflow application only
  • 208/230-1-60 supply voltage
  • Fresh air intake holes (capped from factory)
  • Units fits between standard stud spacing
  • All service access is located in the front
  • Primary and secondary drain connections exit from the bottom
  • No return-air ductwork required in specific applications